Search found 494 matches
- Tue Feb 26, 2019 8:23 am
- Forum: SDRuno
- Topic: Not saving windows
- Replies: 20
- Views: 58975
Re: Not saving windows
Ah, in version 1.23 it's on page 18 onwards. I was looking at v1.22. I think the method is the same though. You might also find help on the SDRUno page on Facebook. It's a busy site with lots of helpful people.
- Mon Feb 25, 2019 10:13 pm
- Forum: SDRuno
- Topic: Not saving windows
- Replies: 20
- Views: 58975
Re: Not saving windows
Hello. The method outlined on pages 12 &13 of the manual is correct as far as I recall.
- Tue Feb 19, 2019 5:09 pm
- Forum: SDRplay related
- Topic: RSP2 no BBC Radio 4 on LW?
- Replies: 9
- Views: 26900
Re: RSP2 no BBC Radio 4 on LW?
Wide, buzzing carriers from switch-mode PSUs are a pain in the neck on LF. The best you can do is to use a loop antenna sited as far as possible from any suspected source of noise. Not easy these days! For feeding the Hi z connector with coax, link N to G and connect outer to G and inner to P. For a...
- Tue Feb 19, 2019 11:13 am
- Forum: SDRplay related
- Topic: RSP2 no BBC Radio 4 on LW?
- Replies: 9
- Views: 26900
Re: RSP2 no BBC Radio 4 on LW?
Yes, the MW/FM rejector disappears in H-z mode. A homebrew LPF (or a commercial one) is a good idea, as is careful control of the RF gain/attenuation slider.
- Tue Feb 19, 2019 9:23 am
- Forum: SDRplay related
- Topic: RSP2 no BBC Radio 4 on LW?
- Replies: 9
- Views: 26900
Re: RSP2 no BBC Radio 4 on LW?
Oh yes, the RSP2 does indeed receive well down to VLF. It's my 'go to' LF receiver, as it works well right down to 15 kHz at least. It's all there, BBC R4, MSF (60 KHz) and all the other stuff including SAQ on 17.2 kHz on those special occasions. The Hi-Z port is best for LF, but you should get resu...
- Mon Feb 18, 2019 11:26 am
- Forum: New Users' experiences
- Topic: SOUND BUFFERING ABOVE SAMPLE RATE 5
- Replies: 12
- Views: 37604
Re: SOUND BUFFERING ABOVE SAMPLE RATE 5
I use my RSP2 with SDRUno and it runs without problem. Below 6 MHz sample rate I can surf the web, play music etc at the same time, but above this I have to reduce the processor load a bit. SDRUno running on its own will reach 10 MHz b/w without any glitching. This is v1.22 and my laptop is a mid-sp...
- Sun Feb 17, 2019 11:10 am
- Forum: SDRuno
- Topic: My winndow only goes down to 120 dbm
- Replies: 6
- Views: 18199
Re: My winndow only goes down to 120 dbm
Hello. The displayed noise level will depend on the sample rate/bandwidth you have selected. Try selecting a narrow bw (maybe 2MHz sample rate with 8 decimation) and then a wider one (try 2 MHz with 1 decimation) and you will see the difference.
- Fri Feb 15, 2019 7:45 pm
- Forum: SDR Antennas
- Topic: RA0SMS vs PA0RDT Active Mini Whip - RA0SMS is Very Noisy - Why?
- Replies: 21
- Views: 138338
Re: RA0SMS vs PA0RDT Active Mini Whip - RA0SMS is Very Noisy - Why?
Peaks every 10 kHz sounds familiar - where are you located? If you are in the USA, then this may be intermodulation from MW broadcast stations which are spaced by 10 kHz. It sounds like the RA0SMS antenna may be a sub-standard design compared to the PA0RDT. Yes, I am in the US. I tried a broadcast ...
- Fri Feb 15, 2019 3:19 pm
- Forum: SDR Antennas
- Topic: RA0SMS vs PA0RDT Active Mini Whip - RA0SMS is Very Noisy - Why?
- Replies: 21
- Views: 138338
Re: RA0SMS vs PA0RDT Active Mini Whip - RA0SMS is Very Noisy - Why?
Peaks every 10 kHz sounds familiar - where are you located? If you are in the USA, then this may be intermodulation from MW broadcast stations which are spaced by 10 kHz. It sounds like the RA0SMS antenna may be a sub-standard design compared to the PA0RDT.
- Sat Feb 09, 2019 1:19 pm
- Forum: SDR Antennas
- Topic: What’s going on here ?? Receiving but no antenna
- Replies: 14
- Views: 43082
Re: What’s going on here ?? Receiving but no antenna
I've lost track - is it picking stuff up with nothing connected to the antenna socket, or with the balun connected?