RSP2 AND SDRuno V1.3/1.31
RSP2 AND SDRuno V1.3/1.31
Just a straight-forward and not loaded question:
Does or has anyone else operated a RSP2 successfully in Low IF (LIF) mode using V1.3/1.31 as a stand-alone rwcwiver (with no other RX/VRX) in use), or will it only operate in Zero IF mode?
Does or has anyone else operated a RSP2 successfully in Low IF (LIF) mode using V1.3/1.31 as a stand-alone rwcwiver (with no other RX/VRX) in use), or will it only operate in Zero IF mode?
Reason: No reason
Re: RSP2 AND SDRuno V1.3/1.31
Hi Mike
Thanks for your response.
Do you mean that it does work in low IF on V1.3 but not 1.31 or do you mean that you haven't used/tried it on V1.31?
Thanks for your response.
Do you mean that it does work in low IF on V1.3 but not 1.31 or do you mean that you haven't used/tried it on V1.31?
Reason: No reason
Re: RSP2 AND SDRuno V1.3/1.31
No, it works on both versions. This is the primary reason I don't use 1.31: https://www.sdrplay.com/community/viewt ... =11&t=4369
Reason: No reason
Re: RSP2 AND SDRuno V1.3/1.31
Hello Paul,
I have the latest SDRuno installed and have since it came out. I use a RSP 2 and I have zero problems with either setting. You can manually change from LIF to ZIF. In my case I just use LIF most of the time, but a switch to ZIF allows me to change from viewing 2 megabytes of spectrum to 10 in ZIF. LIF is meant to be used the most as it relieves errors with LO changing. Good luck.
I have the latest SDRuno installed and have since it came out. I use a RSP 2 and I have zero problems with either setting. You can manually change from LIF to ZIF. In my case I just use LIF most of the time, but a switch to ZIF allows me to change from viewing 2 megabytes of spectrum to 10 in ZIF. LIF is meant to be used the most as it relieves errors with LO changing. Good luck.
Last edited by John55 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason