Changes in calibration Level and Noise floor
Changes in calibration Level and Noise floor
I am applying a calibration signal to the SDRPlay RSP2 Pro and have, on several occasions, seen the noise floor and the recorded signal level drop abruptly by roughly 3 dB. The signal input level is constant - I am monitoring it also on another receiver setup (FCDP+) The levels have never gone higher. In the latest test there is a period of over 7 hours at one level, a drop to a level maintained for around 3 hours and then another drop. The calibration signal is 30 dB above the noise floor. Any ideas ?
Last edited by MTG on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Changes in calibration Level and Noise floor
The drop in signal level and noise floor does NOT happen when using SDR Console V3. So this does appear to be a bug in SDRuno. Is there a way of posting bug reports or is this it?
Last edited by MTG on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason