Tuning Freq's From the Memory ?

[Robert11]

Hello,

Have been able to import eibi into the Memory panel screen.
Shows up fine.

But clicking on a frequency does not seem to tune the radio.
However, if I do a STORE first on a particular frequency, it does tune fine.

What I would like to be able to do, I think, is to simply
go down the list, and click on different frequencies, and have
the radio tune to that one (without the STORE first requirement for that frequency).

How do I do this, please ?

I should note that I am using CSVUserListBrowser to tune the radio.
It works fine doing this.

Is this interfering with the above, or more likely I just don't know how
to tune the radio directly from the eibi listing in the Memory Panel.
I would like both capabilities, if possible.

BTW: for any frequencies that I actually do a STORE on: How do I recall them ? Where do they show in some list ?

Thanks, as always. In my 80's now, and I admit that I miss many of the nuances apparently.
Really appreciate the help.

BTW: if anyone might take a look at my one or two previous very recent questions, too, would be grateful.
Thanks,
Bob

[mikeladd]

Check that the (MCTR) button is active and lit within the RX CONTROL panel. This will activate memory click tuning.