RSP2 AND SDRuno V1.3/1.31

Discussions about everything to do with SDRuno
Paul
Posts: 325
Joined: Fri Feb 17, 2017 9:52 am
Location: SW UK

RSP2 AND SDRuno V1.3/1.31

Postby Paul » Mon Apr 29, 2019 3:17 pm

Just a straight-forward and not loaded question:
Does or has anyone else operated a RSP2 successfully in Low IF (LIF) mode using V1.3/1.31 as a stand-alone rwcwiver (with no other RX/VRX) in use), or will it only operate in Zero IF mode?

Reason: No reason

Mike2459
Posts: 278
Joined: Mon Jul 24, 2017 8:24 pm

Re: RSP2 AND SDRuno V1.3/1.31

Postby Mike2459 » Mon Apr 29, 2019 4:49 pm

Yes, everyday. Version 1.3 but NOT 1.31

Reason: No reason

Paul
Posts: 325
Joined: Fri Feb 17, 2017 9:52 am
Location: SW UK

Re: RSP2 AND SDRuno V1.3/1.31

Postby Paul » Mon Apr 29, 2019 8:06 pm

Hi Mike
Thanks for your response.
Do you mean that it does work in low IF on V1.3 but not 1.31 or do you mean that you haven't used/tried it on V1.31?

Reason: No reason

Mike2459
Posts: 278
Joined: Mon Jul 24, 2017 8:24 pm

Re: RSP2 AND SDRuno V1.3/1.31

Postby Mike2459 » Mon Apr 29, 2019 10:39 pm

No, it works on both versions. This is the primary reason I don't use 1.31: viewtopic.php?f=11&t=4369

Reason: No reason

John55
Posts: 5
Joined: Sat Mar 16, 2019 7:14 pm

Re: RSP2 AND SDRuno V1.3/1.31

Postby John55 » Tue Apr 30, 2019 3:11 am

Hello Paul,

I have the latest SDRuno installed and have since it came out. I use a RSP 2 and I have zero problems with either setting. You can manually change from LIF to ZIF. In my case I just use LIF most of the time, but a switch to ZIF allows me to change from viewing 2 megabytes of spectrum to 10 in ZIF. LIF is meant to be used the most as it relieves errors with LO changing. Good luck.
Last edited by John55 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Paul
Posts: 325
Joined: Fri Feb 17, 2017 9:52 am
Location: SW UK

Re: RSP2 AND SDRuno V1.3/1.31

Postby Paul » Tue Apr 30, 2019 4:40 am

Thanks Mike quite clear.

Reason: No reason


Return to “SDRuno”

Who is online

Users browsing this forum: No registered users and 6 guests