Page 1 of 1

RSP2 AND SDRuno V1.3/1.31

Posted: Mon Apr 29, 2019 3:17 pm
by Paul
Just a straight-forward and not loaded question:
Does or has anyone else operated a RSP2 successfully in Low IF (LIF) mode using V1.3/1.31 as a stand-alone rwcwiver (with no other RX/VRX) in use), or will it only operate in Zero IF mode?

Re: RSP2 AND SDRuno V1.3/1.31

Posted: Mon Apr 29, 2019 4:49 pm
by Mike2459
Yes, everyday. Version 1.3 but NOT 1.31

Re: RSP2 AND SDRuno V1.3/1.31

Posted: Mon Apr 29, 2019 8:06 pm
by Paul
Hi Mike
Thanks for your response.
Do you mean that it does work in low IF on V1.3 but not 1.31 or do you mean that you haven't used/tried it on V1.31?

Re: RSP2 AND SDRuno V1.3/1.31

Posted: Mon Apr 29, 2019 10:39 pm
by Mike2459
No, it works on both versions. This is the primary reason I don't use 1.31: https://www.sdrplay.com/community/viewt ... =11&t=4369

Re: RSP2 AND SDRuno V1.3/1.31

Posted: Tue Apr 30, 2019 3:11 am
by John55
Hello Paul,

I have the latest SDRuno installed and have since it came out. I use a RSP 2 and I have zero problems with either setting. You can manually change from LIF to ZIF. In my case I just use LIF most of the time, but a switch to ZIF allows me to change from viewing 2 megabytes of spectrum to 10 in ZIF. LIF is meant to be used the most as it relieves errors with LO changing. Good luck.

Re: RSP2 AND SDRuno V1.3/1.31

Posted: Tue Apr 30, 2019 4:40 am
by Paul
Thanks Mike quite clear.