Bias-T not working in v1.31 update
Posted: Wed May 15, 2019 10:33 am
I installed the new update today (v1.31). Everything appeared to install correctly.
However, the Bias-T does not work in SDRuno now, under v1.21 it worked flawlessly for 18 months or more. Has anyone else found this trouble?
When fired up the spikes are showing, Bias-T is white (showing that it is working) then I switch it off and the spikes, instead of disappearing, remain at the same height Switch it back on, spikes remain the same.
Checked the plug with a meter and it shows a voltage of 4.6. As mentioned has anyone else found this problem with SDRuno.
I am using the SDRplay RSP1a, Computer is W10, is relatively new with a 1080 N'Videa card, 16GB RAM quad Core with SSD hard drive.Using the SRDuno v1.31 upgrading from v1.21.
Regards
zl2bmh/Jim
However, the Bias-T does not work in SDRuno now, under v1.21 it worked flawlessly for 18 months or more. Has anyone else found this trouble?
When fired up the spikes are showing, Bias-T is white (showing that it is working) then I switch it off and the spikes, instead of disappearing, remain at the same height Switch it back on, spikes remain the same.
Checked the plug with a meter and it shows a voltage of 4.6. As mentioned has anyone else found this problem with SDRuno.
I am using the SDRplay RSP1a, Computer is W10, is relatively new with a 1080 N'Videa card, 16GB RAM quad Core with SSD hard drive.Using the SRDuno v1.31 upgrading from v1.21.
Regards
zl2bmh/Jim