Detector types?
Posted: Thu Jun 28, 2018 8:06 am
Forgive me if this has already been answered, as I only received my RSP2 pro yesterday, and loaded up the Spectrum Analyser s/w this morning!
Having both the output from a peak and an average detector is almost mandatory. A quasi-peak detector might well be rather more difficult.
The ability to set the bandwidth of the detector would be very useful if (as a design engineer in a small company) I would wish to use this to do a quick pre-compliance check on the conducted emissions output (from a LISN through a limiter/attenuator) before going to an EMC test house.
I await further updates to the s/w with interest. It is a remarkable bit of work already!
Regards,
Chris Morriss
Having both the output from a peak and an average detector is almost mandatory. A quasi-peak detector might well be rather more difficult.
The ability to set the bandwidth of the detector would be very useful if (as a design engineer in a small company) I would wish to use this to do a quick pre-compliance check on the conducted emissions output (from a LISN through a limiter/attenuator) before going to an EMC test house.
I await further updates to the s/w with interest. It is a remarkable bit of work already!
Regards,
Chris Morriss