Page 1 of 1

Ant Input: RSP And RSP-2 Ant A Input ?

Posted: Tue May 07, 2019 9:38 pm
by Robert11
Hi,

Have been trying to get the program Sigmora working.
It was written a number of years ago, and now is said to work with the RSP.
Presumably an RSP-1, as there was no RSP-2 when written.

I have a RSP-2

So, is it "reasonable", or correct, to assume that the program probably looks
at the RSP-2 Ant A input ?

**Would the Ant A input on the RSP-2 be the same as the single input on the RSP-1

Or, impossible to determine what, if anything, is or might be equivalent ?

Thanks,
Bob

Re: Ant Input: RSP And RSP-2 Ant A Input ?

Posted: Thu May 09, 2019 9:35 am
by sdrom33
Hi Bob,

I see from your posts you are jumping from one software to another practically every day, while you did not report if at least you now work with your RSP2 and SDRuno without problems...I wish to help if you still encounter difficulties!

Re: Ant Input: RSP And RSP-2 Ant A Input ?

Posted: Thu May 09, 2019 4:47 pm
by Robert11
Hi,

Thanks for interest and help.
Very appreciated.

Yes, SDRUno works fine for me.
Really enjoy it. A lot.
Can't begin to imagine all the hours that must have gone into developing it.

But, have got to admit, that I also enjoy
playing around with the other SDR packages that are out there.
They are all different, have different nuances, interfaces, etc.
Fun to try out the different ones.

Shame it is not possible to take this from one, and something else from another, etc., and put them all together into a single one !

Will also start playing around with some of the digital mode software like Multipsk and Signora.
Have never tried the digital world.

Stay in touch.

Best regards,
Bob