Page 1 of 1

Problem with image 0.5

Posted: Wed May 15, 2019 1:54 pm
by Fab57
Good afternoon,

My Raspberry pi 3 is a model B build in 2015. I use a 3A power supply. I did Sudo apt-get update, upgrade and rip-update but my rsp1a is not seen by the system.
Cubic SDR says: failed to connect to device.
I saw another message like missing libraries or device.

My rsp1a works under windows 10. The Rasp model B seems to be usable with a Sdrplay.

I haven’t found any answers on Internet. Nobody reports a such issue.

Some ideas?

Thank you. 73.
Fabien

Re: Problem with image 0.5

Posted: Mon May 20, 2019 7:31 pm
by AMandaG
Fab57 wrote:Good afternoon,

My Raspberry pi 3 is a model B build in 2015. I use a 3A power supply. I did Sudo apt-get update, upgrade and rip-update but my rsp1a is not seen by the system.
Cubic SDR says: failed to connect to device.
I saw another message like missing libraries or device.

My rsp1a works under windows 10. The Rasp model B seems to be usable with a Sdrplay.

I haven’t found any answers on Internet. Nobody reports a such issue.

Some ideas?

Thank you. 73.
Fabien

I also have the similar isues here that I am facing. If someone can help it would be great.

Thanks in advance,
Regards,
Amanda

Re: Problem with image 0.5

Posted: Sat Jun 01, 2019 8:25 pm
by Fab57
Goodevening,

The issue seems to be coming from the power supply. I bought a new one on Amazon:
https://www.amazon.fr/BERLS-Adaptateur- ... B0768XFP9X

Sorry, it’s Amazon France but I’m sure you will be able to find the same...

Now, it works fine but no sound like some others users :-(

Regards,

Fabien