Is RSP2 IF connection to R8500 safe (9VDC)?
Posted: Mon Dec 31, 2018 1:26 am
I was going to connect my RSP2 to the IF output on my Icom R8500, but noted that jack outputs a 10.7 MHz IF signal with 9VDC. Is direct cabling safe with that 9VDC on the center pin?
I could just connect to a Tee at the receive antenna port of the R8500 ... was hoping for wider bandwidth of IF connection.
thanks
greg
I could just connect to a Tee at the receive antenna port of the R8500 ... was hoping for wider bandwidth of IF connection.
thanks
greg