CW AFC and ZAP do not work

Discussions about everything to do with SDRuno
Post Reply
Mike2459
Posts: 318
Joined: Mon Jul 24, 2017 8:24 pm

CW AFC and ZAP do not work

Post by Mike2459 » Sun Nov 04, 2018 1:11 am

The workarounds previously mentioned do not work either.

Reason: No reason

g4enz
Posts: 40
Joined: Tue Nov 29, 2016 1:17 pm

Re: CW AFC and ZAP do not work

Post by g4enz » Sun Nov 04, 2018 10:48 am

Mike,

They do work, sort of. You'll get problems with them depending upon what you have done with SP2. If you leave SP2 fully zoomed out, then they will work. You can zoom SP2 in a little but DON'T slide the display to centre up the CW passband. Once you do this it all goes wrong. Zoom back out fully and ZAP will start working again. As for CW AFC, assuming that you've followed the advice above regarding SP2, it has a go but isn't too helpful. It quickly gets bored and wanders off very easily to find something stronger to listen to. During even short pauses in transmission, without any other signals visible in SP2, it will still go off for a tune. Why does it do this!?

73 Martin - G4ENZ

Reason: No reason

Mike2459
Posts: 318
Joined: Mon Jul 24, 2017 8:24 pm

Re: CW AFC and ZAP do not work

Post by Mike2459 » Sun Nov 04, 2018 5:09 pm

LOL, "They do work, sort of".

That's why I'm not rushing out to purchase the new SdrDuo.

Reason: No reason

g4enz
Posts: 40
Joined: Tue Nov 29, 2016 1:17 pm

Re: CW AFC and ZAP do not work

Post by g4enz » Sun Nov 04, 2018 9:01 pm

You wouldn't buy a Duo just because the CW AFC is a bit awkward? :shock:

Reason: No reason

Mike2459
Posts: 318
Joined: Mon Jul 24, 2017 8:24 pm

Re: CW AFC and ZAP do not work

Post by Mike2459 » Sun Nov 04, 2018 11:26 pm

If the issue had been addressed then that in itself wouldn't be a factor. ;)

Reason: No reason

Post Reply