How to change Freq step
How to change Freq step
Hello, using a rsp1a on 40mtr ham band. the freq step tuning is locked on 100khz. Anyway to change it to 25khz or less?? 100khz making it difficult to pick out signal in the mud....i'm a new user---probably missed it in manual
thanks,
thanks,
Last edited by fuel300 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: How to change Freq step
If you are using SDRUno, there is a bug which erroneously selects 100 KHz (instead of 100 Hz) when in LSB. You can correct it by following the normal procedure for step size selection as per the manual. The manual is available via the OPT menu.
Or you can hover the mouse over the relevant digit in the frequency display and use the mouse wheel to tune in any decade step down to 1 Hz.
I think the bug is due for correction in the next update.
Or you can hover the mouse over the relevant digit in the frequency display and use the mouse wheel to tune in any decade step down to 1 Hz.
I think the bug is due for correction in the next update.
Reason: No reason
Andy
Re: How to change Freq step
Thank you for your reply. I will investigate uno manual again, also using "hover method". I was away or i would have responded sooner---thank's again...
Last edited by fuel300 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason