Page 1 of 1
Weird behaviour simply changing the SR
Posted: Thu Jul 12, 2018 2:44 pm
by Patrick73
Hi !
I noticed something 'strange' by simply increasing the SR, from 2 to 6, in ZIF mode, dec set to 1.
See the attached captures, all centred on the same frequency.
What happens ?
Re: Weird behaviour simply changing the SR
Posted: Thu Jul 12, 2018 2:47 pm
by Patrick73
Part 2 :
Re: Weird behaviour simply changing the SR
Posted: Thu Jul 12, 2018 2:51 pm
by sdrplay
The IF bandwidth can be either 200, 300, 600, 1536, 5000, 6000, 7000 or 8000 kHz
So for sample rates of 2, 3 and 4 MHz, the 1536 kHz IF bandwidth is used, so you will see attenuation of the signal outside of the IF bandwidth. At 5 MHz, the 5 MHz IF bandwidth is used, so that's why it looks "normal" again.
Best regards,
SDRplay Support
Re: Weird behaviour simply changing the SR
Posted: Thu Jul 12, 2018 3:11 pm
by Patrick73
Thanks for the explanation.
Best regards.