Rig Control Delay - IC7300
Rig Control Delay - IC7300
I am using SDRuno/RSP1A as a panadaptor for an Icom 7300. Works well except - there is a few second delay between clicking/selecting a signal on the SDRuno display and a reaction by the 7300. I have tried several speeds between the PC and the 7300 but basically the problem remains. If I quickly use the mouse roller to change frequency SDRuno slowly steps the 7300 through all of the intervening frequencies eventually arriving at the chosen frequency. Not a disaster but could be better.
Dick N3HKN
Dick N3HKN
Reason: No reason
Re: Rig Control Delay - IC7300
Do you have bidirectional synchronization enabled (so if you change the frequency on the 7300, SDRUno would follow)? I see the same problem with an old FT990 at our club station but did not investigate it yet. If I configure the unidirectional synchronization SDRUno -> FT 990, the TRX follows SDRUno without delay.
Reason: No reason