Panadapter question - mouse click issue
Posted: Thu Aug 01, 2019 5:18 am
I have my SDRPlay RSP2 hooked up as a panadapter for my Kenwood TS850. I have the IF out hooked to the SDRplay input and am using omni rig to control the transceiver. For the most part it works great. I can use the mouse wheel to change frequencies and I can also change frequencies directly in the RX control window and my Kenwood TS850 goes to where ever SDRuno is at.
It works great except one issue. Whenever I use rig control and run it like described... and I click on an area in the main spectrum window it does NOT go to the frequency I click. The mouse wheel works to change frequencies but I can't just click on a frequency in the spectrum and have it go to that frequency. If I'm using SDRuno whiteout rig control it works. But as soon as I use rig control and it goes to the IF of my transceiver, I can no longer click and have it go to that frequency. Unfortunately it makes it a lot more cumbersome to get to the signals I see on the spectrum.
Does anyone else have this problem? Am I missing something? I've looked through the settings dozens of times and can't find a way to do it. Any help would be very very much appreciated.
Daniel
It works great except one issue. Whenever I use rig control and run it like described... and I click on an area in the main spectrum window it does NOT go to the frequency I click. The mouse wheel works to change frequencies but I can't just click on a frequency in the spectrum and have it go to that frequency. If I'm using SDRuno whiteout rig control it works. But as soon as I use rig control and it goes to the IF of my transceiver, I can no longer click and have it go to that frequency. Unfortunately it makes it a lot more cumbersome to get to the signals I see on the spectrum.
Does anyone else have this problem? Am I missing something? I've looked through the settings dozens of times and can't find a way to do it. Any help would be very very much appreciated.
Daniel