Setting up SDRuno to detect Amateur VHF tone coded squelch frequency?
Posted: Wed Sep 04, 2019 8:32 pm
Hi All,
New to SDR and the SDRuno, well not new to SDR as a concept, but new as an owner of the RSPduo.
Got my unit working over the weekend and was listening to various and sundry signals, including some local VHF and UHF repeaters.
Also fired up one of my HTs and transmitted some signals to monitor (I'm a licensed ham). In fiddling around with SDRuno, I did not yet figure out how to set up the display to zero in and see if I could detect the sub-audible tone coded squelch signal being added to the narrow band FM to open up the repeater on the input, or the tone on the output used to open up my receiver's squelch setting.
Any help, hints, on how to do that would be great.
Thanks!
New to SDR and the SDRuno, well not new to SDR as a concept, but new as an owner of the RSPduo.
Got my unit working over the weekend and was listening to various and sundry signals, including some local VHF and UHF repeaters.
Also fired up one of my HTs and transmitted some signals to monitor (I'm a licensed ham). In fiddling around with SDRuno, I did not yet figure out how to set up the display to zero in and see if I could detect the sub-audible tone coded squelch signal being added to the narrow band FM to open up the repeater on the input, or the tone on the output used to open up my receiver's squelch setting.
Any help, hints, on how to do that would be great.
Thanks!