SDRplay Community Forum

This forum is now suspended and will not accept any new posts or account registrations. For technical support relating to SDRplay hardware or software, please open up a support ticket via www.sdrplay.com/support
https://sdrplay.com/community/

Scanner in SDRuno Always switches to ANT-B

https://sdrplay.com/community/viewtopic.php?f=7&t=4905

Page 1 of 1

Scanner in SDRuno Always switches to ANT-B

Posted: Fri Aug 23, 2019 12:13 am
by jonas
Looked through the manual and the forum and did not see this discussed. I have the RSP2pro and when I start up the scanner the SDRuno software switches to ANT-B. Is this normal operation? How can I have scanner function on ANT-A?

Thanks, John.

Re: Scanner in SDRuno Always switches to ANT-B

Posted: Thu Aug 29, 2019 3:21 pm
by scanplorer
Maybe the scan mode is at memory not at range. If this is the case, the saved frequencies are in ANT-B at the memory bank you are scanning.
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/